ChipProg-40 hardware installation

Powering the programmer

Plug the power adapter to the ~110/240V outlet. Connect a plug of the power adapter to the coaxial connector on the rear panel of the programmer and make sure that the "Good" green LED on the programmer is on.
 

Connecting to a PC

Connect a USB port of your PC to a USB connector on the rear panel of the programmer by means of the USB cable. It's highly recommended to connect the programmer to a USB slot on the computer main unit and not connect it through a USB hub, especially through a passive hub.
 

Starting up

Start the Phyton ChipProgUSB program; if the programmer passes the startup test successfully the first dialog prompts you to choose one of the programmers to work with: ChipProg-48, ChipProg-40 or ChipProg-ISP. Select the  ChipProg-40 and continue. The ChipProgUSB main window will open and you will be able to work with the tool.

Powering the programmers

Plug the power adapters of each programmer to be connected in one programming cluster to the 110/240V outlets. Connect plugs of the power adapter to the coaxial connectors on the rear panels of all the programmers and make sure that the "Good" green LEDs on each of them are on.
 

Connecting the programmers to a cluster

Connect USB ports of your PCs to USB connectors on the rear panels of the programmers by means of the USB cables. It's highly recommended to connect the programmers to USB slots on the computer main unit and not connect them through a USB hub, especially through a passive hub.
 

Starting up

Start the Phyton ChipProgUSB - Gang Mode program; if all the programmers pass the startup test successfully the first dialog prompts you to assign the number from one to N to each programmer included in the cluster. To assign the number push a Start button on a top panel of each programmer one by one. Then the ChipProgUSB main window will open and you will be able to work with the tool.