The Options tab

Element of dialog

Description

Buffer:

The field Buffer displays the active buffer to which the programming operations (functions) will be applied. A full list of open buffers is available here via the drop-down menu.

Addresses

Here you can set the addresses for the buffer and the target device to which the programming functions will be applied.

Device start:

The very first address in the target device's physical memory which will be programmed.

Device end:

The very last address in the target device's physical memory which will be programmed.

Buffer start:

The very first address in the buffer memory from which the data will be written to the target device.

Split Data

The group of radio buttons in the Split data field allows to program 8-bit memory devices to be used in the microprocessor systems with the 16- and 32-bit address and data buses. To do this the buffer content should be properly prepared to split one memory file into several smaller files.

Options:

Device-Auto-Detect

If this box is checked then AutoProgramming will start immediately after the ChipProg programmer has detected that the  device is in the programming socket.

Check device ID

By default this option is always on and the ChipProg always verifies the target device identifier given by the device manufacturer. If the box is unchecked the program will skip the device ID checking.

Insert test

If this box is checked the ChipProgUSB will test whether each of the device leads is reliably squeezed by the programming socket contact. If some contact is bad a current operation will be blocked.

Reverse bytes order

If this box is checked the ChipProgUSB will sweep the byte order in the 16-bit word while it executes the Read, Program and Verify operations. This option does not affect the data in the ChipProg buffers, they remain the same after the file loading.

Blank check before program

If this box is checked the ChipProgUSB will always check if the target device is blank before programming it.

Verify after program

If this box is checked the ChipProgUSB will always verify the device content right after it has been programmed.

Verify after read

If this box is checked the ChipProgUSB will always verify the device content right after it has been read out.