|
For the programmer to be used in a single-programming mode:
Powering the programmer
|
Plug the power adapter to the ~110/240V outlet. Connect a plug of the power adapters to the coaxial connector on the rear panel of the programmers and make sure that the "Good" green LEDs on each of them are on.
|
Connecting to a PC
|
Connect the USB port of your PC to the USB connector on the rear panel of the programmer by means of the USB cable. It is recommended to connect the programmer to a USB slot on the computer main unit and do not connect it through a USB hub, especially through a passive hub.
|
Starting up
|
Start the Phyton ChipProgUSB-01 program; if the programmer passes the startup test successfully the ChipProgUSB-01 main window will open and you will be able to work with the tool.
|
For the programmers to be used in a multi-programming mode, e.g. connected to one computer:
Powering the programmers
|
Plug the power adapters of each programmer to be connected in one programming cluster to the 110/240V outlets. Connect plugs of the power adapters to the coaxial connectors on the rear panels of all the programmers and make sure that the "Good" green LEDs on each of them are on.
|
Connecting the programmers to a cluster
|
Connect the USB ports of your PCs to the USB connectors on the rear panels of the programmers by means of the USB cables. It's recommended to connect the programmers to USB slots on the computer main unit and do not connect them through a USB hub, especially through a passive hub.
|
Starting up
|
Start the Phyton ChipProgUSB-01 - Gang Mode program; if all the programmers pass the startup test successfully the first dialog prompts you to assign the number from one to N to each programmer included in the cluster. To assign the number push a Start button on a top panel of each programmer one by one. Then the ChipProgUSB-01 main window will open and you will be able to work with the tool.
|
Read about the Multi-Programming mode.
|