ChipProg-G41

Powering the programmer

Plug the power cord to a power connector on the rear panel of the programmer, then plug an opposite site to the ~110/240V outlet. Make sure that all four "Good" green LEDs on the programmer are on.
 

Connecting to a PC

Connect a USB port of your PC to a USB connector on the rear panel of the programmer by means of the USB cable. It's highly recommended to connect the programmer to a USB slot on the computer main unit and not connect it through a USB hub, especially through a passive hub. Use of the passive USB hubs for connecting the ChipProg-G41 programmer is not allowed.
 

Starting up

Important!  When you start the programmer first time wait for about 20 seconds to allow the USB driver to be setup. Then, every time when you start the programmer, wait for 5...10 sec before launching the ChipProgUSB-01 software.

 
Start the Phyton ChipProgUSB-01 - Gang Mode program; if all the programmers pass the startup test successfully the first dialog prompts you to assign the number from one to N to each programming site. To assign the number push an appropriate Start button on a top panel of the programmer one by one. Then the ChipProgUSB-01 main window will open and you will be able to work with the tool.