The Statistics tab

This tab opens the fild displaying the programming session statistical results - Total number of devices that were programmed during the session, what was the yield (Good) and how many devices have failed (Bad). Getting such statistics is quite helpful when you need to program a series of same type devices. It is important to remember that the statistical counters are affected by executing the Auto Programming only, as execution of other functions makes no effect on the statistics.

Element of dialog	Description
Clear statistics	This button resets the statistics..
Device Programming Countdown	Normally the Total counter increments after each Auto Programming; the , Good and Bad counters also count up. The ChipProgUSB reverses the counters to decrement their content (to count down).
Enable countdown	If the box is checked the ChipProgUSB will count the number of the programmed devices down.
Display message when countdown value reaches zero	If the box is checked the ChipProgUSB will issue a warning when the counter Total is zeroed.
Reset counters when countdown value reaches zero	If the box is checked the ChipProgUSB will reset all the counters when the counter Total is zeroed.
Count only successfully programmed devices	If the box is checked the ChipProgUSB will count only the successfully programmed (Good). All other statistics will be ignored.
Set initial countdown value	Clicking on the button opens the box for entering a new Total number that then will be decremented after each Auto Programming.