Device: CC430F6126IRGC [ISP JTAG Mode]
- Manufacturer(s): Texas Instruments
- Device type: Microcontroller / MSP430
Texas Instruments CC430F6126IRGC [ISP JTAG Mode] is programmed "in-system", i.e. being installed on a board. The matrix below lists Phyton device programmers that support the CC430F6126IRGC [ISP JTAG Mode] device in-system programming and appropriate cable-Adapters or device library licenses.
| CC430F6126IRGC [ISP JTAG Mode] is programmed by | ||
|---|---|---|
| Connection or Adapter | Device programmers | Required license |
| Connection diagrams | CPI2-B1-TI430, CPI2-B1-MSP430 | CPI2-D-TI430 device library license is preloaded |
| Connection diagrams | CPI2-B1, CPI2-Gx | CPI2-D-TI430 device library license is required |
| Connection diagrams | CPI2-B1-x (preloaded) | CPI2-D-TI430 device library license is required |
| AE-ISP-MSP430 | ChipProg-481, ChipProg-48, ChipProg-40 | - |
Recommended CPI2-B1&CPI2-Gx connection (Connection for the TI MSP430Fxxx devices in JTAG Mode with TEST pin)
Powering the target device:
There are two alternative options for powering the targets:
1. The target gets power from the programmer (Vdd). This is possible only if the target does not consume too much energy. A capacity of the target power circuitry should not exceed 50 uF.
2. The target gets power from a built-in or external power supply. In this case the power output from the programmer should not be connected with the target. The target system should be tolerant to applying logical signals with the voltage levels exceeding the voltages on the target.
NOTE! It is strictly prohibited to power the target from both the programmer and built-in or external power supply simultaneously.
Isolating resistors:
Purpose of the resistors is to isolate the programmed chip from rest of target system. Recommended value of resistors is 2k or more. You can also use jumpers instead of the resistors.
ISP characteristics:
1. Programmer''s output capability:
1.1 Vcc - 80 mA with powering from USB and 350mA from external device programmer power supply;
1.2 Vpp - 50 mA;
1.3 logical pins - 5 mA.
2. The cable length should be less then one foot.
/Start is the input signal, active state is 0. This signal works as the Start button on the programmer.
/Error, /Good, /Busy are output logical signals, active state is 0. They indicate the programmer status and work as the corresponding LEDs on the programmer case.
Adapter Connection Table:
All power supply pins included AVdd must be powered. All ground pins included AVss must be connected together.
Go Back